Custom OrderFINISH 11- Bright Chrome 35- Stainless Steel GLASS Clear 12 mm2 PEOPLE REQUIREDIT IS
10RUNNING RAIL 55A5B4 Position the stoppers (4) on the running rail (1) as illustrated. Secure them temporarily in place. Position the wall brackets
117BOTTOM GLASS CLIPSPANNEAU FIXE/FIXED PANEL1GLASS HOLDERS6Insert gaskets in the bottom center guide (7) andglass clip for bottom of xed panel (6).
128B8FIXED PANELPosition the wide xed panel assembly on threshold of the base (B) as shown. Adjust the wall bracket (3) as well as the return
139Mark the screw locations for the wall bracket (3) on the wall as well as the placement the glass clip (6) and bottom center guide (7). THRES
14Remove running rail (1) from brackets (3) (14). Drill holes in walls with a drill bit, intended for ceramic tiles, through to the wall stud. Fasten
1511DOOR PANELInstall door panel (17), ensuring that therollers (2) are positioned over the running rail (1).Ensure that the door panel (17
16STRAIGHT HANDLE13Install set of double rollers to the bottom holes of door panel (17), making sure that they are tangent to the running rail
17/FIXED PANEL1113BOTTOM14DOOR PANEL SIDE GASKET 14Install door panel side gasket (11) onto door panel (17).11 1/2” (12.57 mm)TOP171711
18SILICONE1612Apply silicone (S) between the bottom of the xed panel and the threshold of the base. Silicone application along the l
2 - Read this manual carefully and completely before proceeding.- t cudorPare subject to change without no-tice. Use the installation instructi
3PARTS LISTING12344556789101112131416C16A16B17181512
4PARTS TABLE1 Running rail 12 Set of double rollers 2 sets3 Wall bracket for running rail 14 Door stopper 252637 Bottom center guide 18 Straight handl
5TOOLSHARDWAREPENCILDRILL SILICONESCREWDRIVERSCUTTING PLIER LEVELTAPE MEASURE1/4˝&�1/8˝ DRILL BITS*HACKSAW23 25 26 27MALLET BLOCK192120 22 2419 Se
6WALL JAMB INSTALLATION11C1DPut a drop of silicone into each hole drilled on the wall prior to insert an orange wall plug (23).Reposition and fasten t
72DOOR PANELUsing the cardboard packaging box as platform, install bottom door gasket (13) onto door panel (17) using a block and a malle
83CONTINUED3DMark the glass clips for bottom of xed panel (6) locations on the base, ensuring that the leading edge of the return panel is ta
94CONTINUED3HOnce the return panel (16b) has been adjusted, secure the expander (15) to the wall jamb (16a) by way of a clamp so as to
Kommentare zu diesen Handbüchern