INSTALLATIONINSTRUCTIONS1040 & 1050 SERIESHEAVY FRAMELESS BYPASSBATH ENCLOSURECopyright © Alumax Bath Enclosures 2014. All rights reserved.G03711
Page 2 of 9G0371109511-4-14 August 18, 2014 Three-Year Limited Residential Warranty Alumax Bath Enclosures by Sapa is pleased to warrant to its dealer
Page 3 of 9G0371109511-4-144292779.1!WARNINGS!Alumax Bath Enclosures by Sapa are intended to be installed by experienced installers.
Page 4 of 9G0371109511-4-14 1040/1050 PARTS LISTA.1 Tub TrackB.2 Wall JambsC.6 Wall AnchorsD.6 #8 x 1 1/2" Truss Head ScrewsE.4 Jamb BumpersF.1 H
Page 5 of 9G0371109511-4-14 Use a level to plumb both wall jambs [B], then mark the pre-drilled hole locations on the wall. Lightly mark both sides
Page 6 of 9G0371109511-4-1446 NOTE: Obscure glass doors should be installed with the rough surface of the glass to the exterior of the unit. Deco or
Page 7 of 9G0371109511-4-147 Attach the four one inch roller bearings [K] to the door hanger brackets [G] as shown, using #8-32 x 3/8” hex head screw
Page 8 of 9G0371109511-4-141210 Locate the four, large hole, plastic washers [M] and place them over the threads and flush with the four end caps [N
Page 9 of 9G0371109511-4-14 Neatly caulk each end of the tub track [A] where it meets the wall jambs [B] and along the interior edge of the wall ja
Kommentare zu diesen Handbüchern